NANCY'S TRAINS YOUR DCC DECODER SOURCE

Quantum Engineer
Advanced Analog Controller. With Quantum Engineer, you can operate features that are otherwise available only in DCC plus features that are not yet available in DCC.
List $59.95

Quantum Engineer

Advanced Analog Controller
In stock and shipping. List $59.95.

Later Quantum locomotives are equipped with our new QSI QARC™ (Quantum Analog Remote Control) Technology, which uses special remote control signals to operate different Quantum features without the need for complicated and expensive digital systems like DCC. Add the simple QARC controller, called Quantum Engineer, to your existing Analog power pack as shown above. With Quantum Engineer, you can operate features that are otherwise available only in DCC plus features that are not yet available in DCC.

• Turn On or Off Lights including Headlight, Reverse Light, optional Cab Lights and Number Board Lights. In addition, you can turn on or off optional Hazard Lights (Mars or Ditch-lights) plus switch them to be on steady or strobing.
• Shut Down and Start Up Locomotives. Complete Shut Down takes the engine off-line where it will not respond to either the throttle or other commands. Two types of Shut Down and Start Up scenarios are available; a short version where the Start Up and Shut Down effects take very little time or extended scenarios which includes locomotive preparation and/or maintenance effects.
• Operate Prototype-like Air Brakes. The Apply Brakes button results in the engine sounds reducing to idle while you hear the hiss of the air-line pressure progressively decreasing causing the engine to slow. You control the amount of air pressure and amount of braking effect. The Release Brakes button causes the engine sounds to return to normal as the locomotive’s speed gradually increases back to its original setting.
• Turn on Dynamic Brakes. Press the Dynamic Brakes button and hear the diesel motor reduce to notch 1 while the sounds of the powerful Dynamic Brakes and Cooling Fans turn on. Press the Dynamic Brakes button again to turn Dynamic Brakes off while the engine sounds return to their original power level.
• Change System Volume while Train is Operating. The engine volume can, of course, be set with manual volume control or through programming. The Quantum Engineer allows you to change volume up or down at the touch of button whenever the locomotive is operating.Mute Engine Sounds while Train is Operating. Presses the Mute button to gradually reduce the volume to a lower level or increase it gradually back to normal. This feature is valuable to lower the sound to allow answering the phone or to have a conversation but also as a way to easily lower the sound of engines in the background area of the layout or increase the sound volume as the engine moves to the front of the layout.
• Disconnect the Motors. The Disconnect button turns the motor drive off allowing you to operate the throttle without the engine moving. You can rev the diesel engine or vent steam through the throttle on steam locomotives. You can even apply Dynamic Brakes to allow the engine to operate under labored conditions – a common practice on prototype diesels to test the motor/generator output.

Download sound files from your PC and program CVs.
In stock and shipping. List $99.95.

Interfaces between your PC and a program track, which allows downloading software and new future sounds directly from your PC and from the QSI website directly into an UPGRADED Quantum Sound System without disassembling your locomotive.

Setting Up the Quantum Programmer ... at a Glance

Review All Instructions

1. Quantum Programmer Installation Guide
2. a. Q1a Upgrade User Manual 1.0.3. (Q1a Upgrade is Programmer's PC Operating Software)
   b. Q2Upgrade User Manual 1.4.1.
3. CV Manager User Manual 1.1.2.
   (CV Manager is a PC Assisted Programming Tool)

Quantum Revolution Decoder Style and Recommended Speaker Applications